Dyson V10 Brush Roller End Cap

thingiverse

I somehow managed to break the end cap on my Dyson V10 brush roller. I have a feeling it was caused by the cheap replacement brush roller that is just a smidge longer than the original, so it rubbed until it thinned the plastic and it broke. I wasn't able to find one on Thingiverse so I made one! It took a few iterations to get the location of the locking tabs correct but it works well and locks in securely. It is a snug fit on the bearing, but if you run some sandpaper or a knife over the inside bumps to knock them down some it will go on easier. Its a user modifiable interference fit. No supports were used. I tried to design it in a way so that they are not needed.