E3D Chimera / Cyclops mount for Prusa i3 X-Axis carriage upgrade

thingiverse

This was designed to work with my set of upgraded parts for my Prusa i3 Steel. It is the most basic mount, designed for the E3D Chimera or Cyclops and is designed to fit the upgraded X-carriage (http://www.thingiverse.com/thing:1991116) Two versions are included - one mounts the heatsink and hotend lower down but uses longer mounting screws. Other parts designed for my printers include: http://www.thingiverse.com/thing:1959901 (GT2 belt clamp (Prusa Y-axis) http://www.thingiverse.com/thing:1937232 (Arduino Mega and RAMPS v1.4 case) http://www.thingiverse.com/thing:1905409 (Prusa i3 steel 10mm upgrade) http://www.thingiverse.com/thing:1959974 (Prusa i3 Steel Y-axis motor mount) http://www.thingiverse.com/thing:1991116 (Prusa i3 Steel X-carriage) http://www.thingiverse.com/thing:1991117 (E3D Chimera / Cyclops mount) http://www.thingiverse.com/thing:1994413 (dual E3D Thermocouple amplifier board - housing) http://www.thingiverse.com/thing:1090661 (Belt driven Bowden extruder with 1:2.5 reduction) http://www.thingiverse.com/thing:896676 (enclosure for SevenSwitch FET) http://www.thingiverse.com/thing:922455 (8mm Z-axis leadscrew bearing holder) http://www.thingiverse.com/thing:922309 (Z-axis NEMA 17 adjustable endstop bracket) http://www.thingiverse.com/thing:899607 (cable chain) https://www.thingiverse.com/thing:2334269 (LCD housing) https://www.thingiverse.com/thing:2377049 (PSU cover) https://www.thingiverse.com/thing:2395715 (Chimera & Zesty Nimble drive cable spacer) https://www.thingiverse.com/thing:2407651 (Chimera Zesty Nimble X-axis set for i3 clone) https://www.thingiverse.com/thing:2436869 (A dummy NEMA 17 motor to hold the 5mm shaft) https://www.thingiverse.com/thing:2748978 (A Duet WiFi housing) https://www.thingiverse.com/thing:2749324 (A layer fan for the Smart Effector) https://www.thingiverse.com/thing:2814068 (A Sannce I21AG mount for 3D printers) https://www.thingiverse.com/thing:2844881 (A cooling duct for a Noctua 40mm fan on a Duet Smart Effector) https://www.thingiverse.com/thing:2846955 (A quiet BerdAir type pump mount) https://www.thingiverse.com/thing:3333609 (A Raspberry Pi case with 40mm fan) For avoidance of doubt, this item is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License. See http://creativecommons.org/licenses/by-nc-sa/4.0/ for more details. Print Settings Rafts: Doesn't Matter Supports: No Resolution: 0.2mm Infill: 75% Notes: I printed mine in PLA - feel free to use whatever plastic you like.