E3D V6 FOR UM2 (空中堡垒)

thingiverse

Print advice: Material: ABS or PLA Fill: 30% Storey height: 0.1 - 0.2 mm Note: Don't add supports in any pipe where square nuts are placed unless your support is very well removable. You only need to add supports in the two bearing holes and the top cage. Screw: M3 15mm (6) M3 10mm (2) Nut: Square nut 5.5 * 2.5 mm (6) Fan: 4010 (3) Assembly Description: First, push two square nuts used for locking bearings into the pipe of square nuts. Then put in two bearings and tighten with M3 * 15 screws. Next, push the lock nut of E3D V6 from the top into its corresponding position. Put the E3D back together and lock it tightly. Continue to push the lock holder nut from the top into its corresponding position and lock it tightly. At this point, part of the E3D is installed. Screw the print air duct directly through the M3 * 10 screw into the screw hole at the bottom of the cross slide block. Install all three fans to their corresponding positions. You're done! Start enjoying it!