E3D v6 Two Fan with Ring blowing

prusaprinters

E3D v6 Two Fan with Ring blowing Two new files These have a deeper air ring design that should allow greater air flow round and through the gap in that ring. You can turn air flow down, using PWM, but not increase it from the maximum. E3D v6 Two Fan Ring More Blow Fan Paper Test {Powerful} 50% fan speed should be enough using this:- https://youtu.be/Fzm79LDLCQE This is a two fan fan shroud it is in two half's that bolt clip onto the E3D v6 Hot End This build is based remixed from Techtiptricks E3D V6 Extruder Mount. It is a two fan system that blows a ring of air round the part being printed and a separate fan to blow air across the E3D v6 fins. I would like to acknowledge Techtiptricks E3D V6 Extruder Mount* more below E3D v6 Two Fan Ring blowing fan Paper Test The file only has the name "BLTouch???" in it because I use one of these for auto-levelling; this should have no impact on fitting. E3D V6 Techtiptricks Mount with dual cooling fans Files available here: http://hypedphoto.com/storage/E3D_V6_Extruder_Mount.zip Category: 3D Printer Extruders