E46 Speaker mount 6.5"/16.5cm

thingiverse

!!! READ FIRST !!! So this is a Remix of an existing MidBass mount (Could also be used for some E9X etc. Models of BMW). I would like to say that this is not suiting for E46 all of the parts! This adapters are a copy of an adapters of name Phonocar id number of : 3/938 Adapters that we're in pre-remix, are correct, just not good load capacity on holes, so i will add a file with no holes for a speaker at all so you can make them yourself. Please read part name in file name, so it will suit for your vehicle. I also made a file for a E46 Cabrio rear speakers which has a 130mm original speakers, since i could not find any low profile 130mm speaker i made a reduction on 10cm suits for Crunch DSX 4.2 Components. Fort test print i used PLA so i knew if speaker holes are correct. Holes are a diameter of 5,9mm meant to be mounted with a M4 screw and nut. Holes suits for my speakers which are Component of Crunch GTS 6.2C and for Rear deck Coaxials GTS62, which have the same mounting cage. Also the big hole is meant for this, but i got it a little bit too big, so i can play with holes. I also made a Tweeter mount for front door, for the Tweeters included with Components. No need for mirroring. You cam seal adapters with some silicone or print 0.8mm o-ring from flexible material. 17-4-2022 I also made a lifted version for fronts since i upgraded fronts on my friends car and speakers were a little too deep. Mounting holes are 2,5mm, bored to 3.5 and made M4 thread and M4 x 25mm screw. NOTE: If anyone is looking for a low profile speakers, there is a brand Phoneix Gold which produces them, suits front and rear end of vehicle. Fronts: Phoenix Gold Z 6.5 CS Rears: Z 6.5 CX This are all a 40Watt RMS on 4 ohm load. Suits any low cost budget 2/4 channel amplifier. Know also that you wont be getting alot of bass from this speakers if you have aftermarket radio!