Eachine VR006 Monitor Case

thingiverse

This is my first design. I decided to make this case after seeing someone hack away at a set of the VR006 goggles to make a monitor out of them. Everything fits pretty tight and you'll need a little foam tape to keep the battery from flopping around and to keep the buttons from shifting after multiple uses. I was able to print this with no supports however i did have to clean up 2 of the button holes due to my printer not bridging very well. You can use 2 screws from the original vr006 goggles to put the two halves together. I made the ring in the center on the top half of the case where is can easily pop out (see pic) cause one of my goggles had that port a little higher than the other. If the port is low then it will fit in the hole, if it is high, it will pop out the ring when you press it in and will fit.