Eachine Wizard X220HV DJI Air Unit Retrofit (camera, mount)

thingiverse

I couldn't find a DJI Air Unit design that I liked and I really liked the design Aremgi came up with for the Chameleon and adapted it to the Wizard X220HV. This design preserves the rear stack and can accommodate the factory lost model buzzer. Print the bracket with the flat side (outside surface) down, and mirror it for the other side. The Air Unit holder sits between the rear and middle standoffs. Print the Air unit holder in PETG or PLA, and the antenna holder in TPU. Camera mount should be printed in TPU. NOTE: This design assumes you've used larger standoffs as I did. They can be seen in the pictures. The Air Unit holder and antenna mount will probably work for stock, but the camera mount will not without minor modification. If you are looking for one that uses the stock standoffs check out my remix at https://www.thingiverse.com/thing:4603533 Based on concepts from these things: https://www.thingiverse.com/thing:4034182 https://www.thingiverse.com/thing:3994291