Earbud Holder Table Clip

thingiverse

Was getting annoyed by how my earbud wires were constantly getting caught in various places and being a pain in general when I was working at my desk, so I made this to try to keep it in place. The idea was basically a simple clip that I could pop onto my desk to hold my earbud wire and keep it from wandering around. The way the design works is a tad overdesigned, though it's not too complex. The table clip (table_clip_v2) has two channels on top and on the side that the earbud clip can slide into. table_clip_v2 - The actual clip that fits onto the table (May need resizing for other tables). Earbud Clip V3 - Piece that can slide into the channel on the table clip and has a fully rotating version of the earbud hook built-in. Requires a very well-calibrated printer. wire_holder - Separate piece that can fit into the channels and has 3 hooks for both earbuds and the plug-in cord. earbud_clip_body - Bottom piece of Earbud Clip V3. Has a hole for the rotating hook. Easier to print than Earbud Clip V3, but the hook comes out easily and cannot be used upside down/sideways. earbud_clip_hook - Complement to earbud_clip_body. Same pros/cons apply. earbud_holder - One-piece part that slides into the channels on the table clip and has the hook for the wire built-in. Functionally identical to Earbud Clip V3, except the hook can't rotate. Currently deprecated, though it still works.