Marvel Legends Spider-Man Action Figure Stand

thingiverse

I printed this as a stand for a Marvel Legends Spider-Man figure. Edit: Those notches on the bottom of the base in the picture are not there in the 3D model, the actual base is solid on the bottom. Note, depending on your figure, the foot pegs may not be perfectly sized. Peg holes on figure feet vary a bit in size, so be prepared to cut/file to make them a little smaller, or use a piece of tape to build them up a little bit to make them wider. These should generally be the right size for most figures. Print as it is oriented in the download file, with the spider emblem on its back and the base coming up into the air. You could run some supports under the foot pegs as they may sag a little, but I never do.