ease of print modification of Mini Trash Can

thingiverse

This is a ease of print modification of the [Original Mini Trash Can] (https://www.thingiverse.com/thing:3478317). __If you do not plan in printing the wheels in flexible filament then you will need to use the original print in place wheel part.__ I made the following modifications: * separated wheel and axle so the wheel can be printed in TPE (or other flex filaments) * slightly enlarged the diameter of the bar on the body and shrunk the holes to be filament sized * closed the middle of the base of the body. This will slightly prevent the corners from curling up during print. * replaced the pins on the lid-arms with a filament sized hole * flattened out the lid-arms so they print flat to the printer bed * embiggend the lid grip posts so they are not as fragile This print profits from using variable resolutions and very good cooling. I suggest printing the lid and the very top of the body in 0.16. the rest of the body can be printed in 0.2. For assembling put the lid on the body then push a piece of filament into the holes until they bottom out. cut off with a sharp pair of snips. Alternatively mark the filament and pull it out again and then cut to length with an x-acto knife. Carefully glue to taste