Easter Bunny With Chocolate Bunny Mold

cults3d

Adam's Easter Bunny With Chocolate Bunny Mold. Download Exclusive to Cults3D.com Easter Bunny The example model in the images was printed at 65% scale. Printing smaller than 65% will cause some details to be lost. Slice with Cura, 65% scale or larger is recommended. Raft & Supports are needed. 2 Part Chocolate Bunny Mold (Also creates a Mini Egg). You may not need Raft or Support for printing the mold. You may also need to adjust the infill settings to ensure the inside of the mold prints correctly, depending on which way up you place the model in Cura. I would recommend using Silk PLA as it has a very smooth finish, even at 0.2mm layer height. Any other food safe filaments should be ok. Smaller layer heights would also give a smoother finish. Take care to clean the inside of the mold before use, to ensure there are no plastic particles left over from the printer. Note: I have done my best to smooth out the inside of the mold with the sculpting tools, to ensure that chocolate will release from it without breakage. You may need to heat it up and press flat any edges which cause the chocolate to get locked into the mold. Please leave me a comment at the bottom of this page if you have any issues. Thanks! To use the mold: Spread melted Chocolate around the inside of the mold with a spoon or other utensil, then place in the fridge to set. Carefully remove the Chocolate Bunny, tail first. Melt the edges of the Chocolate Bunny halves (and the mini egg) or apply extra hot chocolate around the edges to bond the two sides together. You might wish to place some sweets inside too! Files included in this Download: EasterBunny.stl ChocolateBunny_Mold_L.stl ChocolateBunny_Mold_R.stl Tag Sauce: Easter Bunny, Chocolate Bunny, Bunny, Rabbit, Chocolate, Easter, Easter Egg, Mini Egg, Egg, Egg Mold, Bunny Mold, Art, 3D, print, printing, printed, printer, model, 2020, toy, figurine, sculpture, statue, figure, animal,