Easter Egg (Egg for Eggs)

prusaprinters

<p>This is a container for Jelly beans or small chocolate eggs.<br/> I have designed it from scratch based on the idea from muzz64, <a href="https://www.thingiverse.com/thing:3537163">https://www.thingiverse.com/thing:3537163</a></p> <p>You can open or close the egg by rotating the outer shell in regards to the inner shell.</p> <p>You can use it as a small Easter gift to a child or grandchild. Do not forget to fill it, after printing, with jelly beans!</p> <p>The total height is 10 cm.</p> <p>There are 2 versions with "Happy Easter" and one version without text.<br/> When you want to change the text ("Happy Easter") give me a notice with your email address and I will send you the Fusion 360 file so you can change the text.</p> <p>Print it carefully, the walls are only 1.2 mm and the separation between the inner and the outer shell is only 1 mm.</p> <h3>Print instructions</h3><h3>Category: Containers Summary</h3> <p>This is a container for Jelly beans or small chocolate eggs.<br/> I have designed it from scratch based on the idea from muzz64, <a href="https://www.thingiverse.com/thing:3537163">https://www.thingiverse.com/thing:3537163</a></p> <p>You can open or close the egg by rotating the outer shell in regards to the inner shell.</p> <p>You can use it as a small Easter gift to a child or grandchild. Do not forget to fill it, after printing, with jelly beans!</p> <p>The total height is 10 cm.</p> <p>There are 2 versions with "Happy Easter" and one version without text.<br/> When you want to change the text ("Happy Easter") give me a notice with your email address and I will send you the Fusion 360 file so you can change the text.</p> <p>Print it carefully, the walls are only 1.2 mm and the separation between the inner and the outer shell is only 1 mm.</p> <h3> Print Settings</h3> <p><strong>Printer Brand:</strong> XYZprinting</p> <p><strong>Printer:</strong> da Vinci 1.0 Pro 3in1</p> <p><strong>Rafts:</strong> No</p> <p><strong>Supports:</strong> No</p> <p><strong>Resolution:</strong> 0.3 mm</p> <p><strong>Infill:</strong> 30%</p> <p><strong>Filament:</strong> REC PLA Beige<br/> <strong>Notes:</strong></p> <p>You can also print it with a smaller layer height.<br/> Supports are not needed.</p> <h3> Post-Printing</h3> <p>After printing you probably have to break loose the inner shell, because of stringing or blobs and zits. For that reason there is a small indent in the bottom where you can rotate the inner shell with a coin.</p>