Easter Eggs with filament

cults3d

Easter Eggs with filament Eggs with spiral holes for 1,75 filament For 3mm resize the model to 171-172% Even pure model can be used as a decoration but combined with some nice color filament it will look better :) Cut it to 10,5cm each (4.13inch), or little more (you need 10,3cm but it's better to cut off the rest later) Pliers or some flat metal may be used to push filament in the hole. I started from the top, pushed the end in with pliers and then pushing it all the way down. May not be very easy, depends on filament used and prints options. IMPORTANT TPU will be the easiest to use for PET-G (on photos) or similar flexibility filament you may need pliers to bend both ends. PLA can be used too (I did it on prototypes) but it will break unless you will heat it up - be carefull to not overheat the egg (it will deform) OR cut smaller pieces like 6-7cm instead of 10,5cm and use it in the center only (where we have smaller angles) Made in Blender 3D Printed on Creality Ender 3