EasyThreeD X1/X2 fan duct

thingiverse

The fan duct for the X1/X2 comes in pre-sliced gcode for printing on the X1. I printed it out on my X1 and was not happy with the quality so I converted the gcode back to STL and removed all the supports so I could print it in any orientation on any of my Printers that I wanted. Takes a 25mm fan and is pre-wired under the cover for it. Some issues I had with it are as follows: 1. The fans I got were wired opposite of the plug so I had to swap the wires. They did come with the proper connector on them though 2. The fan rubbed on the fan grill on the X1 shroud so I had to cut the grill out. 3. Seems like the fan is on 100% by default at printer boot, so you have to have it plugged in to a pc/octoprint to turn it off. 4. Fan seems to spin WAY too fast at 100% and gets hot and smells like it is overheating. Seems like 50% power is about right for it. These are the fans I got rather than waiting for 1 fan from China https://www.ebay.ca/itm/10-Pieces-5v-Fan-mini-25mm-x-7mm-2pin-2507-dc-mini-micro-brushless-cooling-A30/264376756245?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649