EB410 SKIDZ

thingiverse

SKIDZ For Tekno EB410. Following on from my 1/8th versions here are the 1/10th versions. Standard front rear in both 2mm and 1mm. Screw hold on 1mm is not great but give it a try. There is also a full front version. Note :- They are all printed flat. To create the bend I suggest bolting them on and then using a heat gun on low temp warm up the plastic enough and then use something flat ( not fingers :( ) to curl the ends over the front bumper and the bend to chassis. For rear I used an allen wrench bar to put a nice bend on rear.