Egg piercer - helps to prevent eggs from cracking while boiling and the shell typically comes off a bit cleaner when peeling

prusaprinters

<p>Before you start, you will need a standard Push-Pin to fit into the final build, along with some CA glue.</p><p>This is an egg piercer which is used to help prevent your eggs from cracking when they get placed into boiling water.</p><p>Without piercing a small hole in the bottom of it, the egg tends to build up pressure which quite often results in it cracking while trying to boil it.</p><p>Just be sure to pierce the correct end (it's the fatter end on the bottom). &nbsp;If you're unsure of which end is which, just float it in some cool water and the end which floats to the top is the end which you should pierce (it's the end with the small air sac).</p><p>For printing, just print two of these, as they fit into each other to form the complete egg piercer.</p>