Eibos Cyclopes Drier Fan Converter

prusaprinters

<p>Eibos Cyclopes Drier's fan is noisy. Inspired by <a href="https://www.prusaprinters.org/prints/51737">https://www.prusaprinters.org/prints/51737</a>, I created another fan converter for Noctua 80mm fan.</p><p>Features (compared to 51737):</p><ul><li>Have hole for fan cable</li><li>Better air flow (I hope so. I'm not sure)<ul><li>Higher (more space to reduce cross-sectional area)</li><li>Larger center air way (the heater area is a rectangle, not a circle)</li></ul></li><li>Compatible with M4 screws and nuts</li></ul><p>Requirements:</p><ul><li>Noctua 5V 80mm fan</li><li>Either (fan screws x4) or (M4x12 screws x4 and nuts x4)</li><li>Bigger stands x4 (from <a href="https://www.prusaprinters.org/prints/51737">https://www.prusaprinters.org/prints/51737</a>)</li></ul><p>Install instructions:</p><ol><li>Unscrew the four stands, open the back panel, and unscrew the original fan</li><li>Remove original fan cable and connect with Noctua's<ul><li>The easier way is cutting the original cable and using Noctua's OmniJoin cable</li><li>Otherwise, be sure the fan is on the other side of the back panel if your new cable is not reconnectable.</li></ul></li><li>Screw the fan onto the fan converter (align with the cable hole)</li><li>Close the back panel (cable hole is on the side)</li><li>Screw the fan converter to the base (through the fan blades; reuse original screws)</li><li>Screw the bigger stands (reuse original screws)</li></ol><p>Print instructions:</p><p>PETG, 0.15mm layer height. No support is needed.</p>