Elbow fitting for water over 1/8" glass edge for 5/8" OD tubing

thingiverse

I needed to take water coming up vertically along a piece of glass and redirect it at a right angle on the other side of the glass. This part allows the water to compactly be redirected without big mess of fittings. Watch the print occur at http://youtu.be/7OoFe0CkZio Instructions The fitting sits on the edge of 1/8" glass, and was designed for 5/8" outer diameter (1/2" inner diameter) clear tubing. In the picture, the water comes up into the fitting the right side and exits the fitting on the left side. After printing it on a Solidoodle 3, I coated it with Loctite plastic epoxy to prevent it from leaking water through the surface. Epoxy should not be applied in the "gap" as it already has a snug against the glass. I recommend sealing up any leaks (e.g. where it grips the glass or where tubes connect) with silicone.