Elder Wand - 2 Parts

thingiverse

The Elder Wand from Harry Potter - I sculpted this in Blender because I wasn't happy with many other models that were available online! The connector may need a bit of sanding to get it to fit and I recommend that you glue it in place once it does fit. I also recommend that you increase the wall width for these wands to make them stronger and slightly heavier (they feel better in hand) You also will need to print with supports (Cura tree supports work very well) Warning - The scaling may go a bit funky, if it does, the small bottom part of the wand should be 18.5 cm tall, so if you scale it in proportion with both parts then it should be the full 15”! They look amazing with the other 3d printable Wand Stand that I modelled and uploaded!!