Eldritch Horror Clue Dispenser

thingiverse

New improved: Thicker tower walls to avoid splitting at the threads, a taller tower to hold more clues and built-in supports for easier printing. The Eldritch Horror clue dispenser holds up to 50 clues. The dispensing mechanism requires a rubber band. The concept for this design comes from [Coin Dispenser/Changer](https://www.thingiverse.com/thing:277758) by [jsc](https://www.thingiverse.com/jsc) Printing: This model includes built in supports. Once printed, cut the supports out from the slots at the base of the tower with a knife. After build, insert the slider into the base. Insert the lever into the slider and snap it into place on the main tower. Finally, add a rubber band around the tower and the lever. If the print was clean, the slider should move freely in the slots. You can trim the sides if necessary with a sharp knife or deburring tool. Note that the connection between the cylinder and the base is not very strong. I've used CA glue to rejoin them.