Electric Hoover Board - Concept

thingiverse

Electric Hoover Board Concept 01 - Mono Board version - Dual Long Board version Maybe an extreme future sportsman could wear a AR HMD with 2 Hi-Res front cameras, so we can overlay a 4K game interface, rendered by a built-in / on-board chip in real-time combined with the real-life electric hoover board action feed. one could then perform tricks in real life and get points in a virtual reality sort of Hud for instance, once detected by the on-board motion detectors that could also be used for in/on-screen gps guidance, navigation, and balance / hoovering assistance (record, calculate and gently counter balance the users center of mass) when not in full Acro/freestyle mode). one could also wirelessly read out the (gps location in relation to the board and the real-world location of the HMD, using the real-time wireless joypad input data for help in generating a artificial reality layer projected within the HMD. And may also be worn in fashionable combination, complimented with a (electric) turbine powered jet-pack of course. theres a plethora of fuel / electricity storage space located within the model, but more extra battery space is available embedded within the jet-pack design itself. Maybe even covering the top and bottom of the outer hull with a photo voltaic film, complimenting the electrically regenerative motion, Re-captured from the lateral movement of the two center axis spinning in both counter-spinning directions. in the Mono model for instance, the combined usage of 18 electric motors, all counter-spinning and working in unison should be able to generate enough lift for carrying a man-sized load, of course depending on scale of the 3D print-out of the hull and fitting electric motors sizes used. a small scale replica or scaled model could easily be realized, as well as have it be equipped with a aerodynamically built into the model 4k camera module. allowing for a unhindered top and bottom intake of fresh air flow to be cast straight downward through the boards design. the Dual model should nearly be twice as strong, carrying twice the amount of electric motors, and also even carries more battery pack weight, so one could finally maybe eventually even put a wind surfing sail / axis, centered on top hull part to allow for real-time sky surfing, using the board for hoovering at altitude and it's altitudinal wind for directional motion of the pilot. maybe i should model it in, maybe i'm taking it a little bit too far, who knows. hope you enjoy the dream (or do you happen to know some one bored from Dubai?) and these screen-shots i made for you with me.