EleksMaker EleksLaser Draw Module Plate and Sled

cults3d

I had an old EleksLaser at home and after I repaired and improved it with carriage tensioners (https://www.thingiverse.com/thing:3422982) and a cable chain (https://www.thingiverse.com/thing:2765001) i thought I am going to build a draw module with the stuff I have at home. So I present the probably cheapest version of a draw module for the EleksLaser! ;-) 2x M6x100 shaft screws 1x mounting plate 1x 3 piece sled (the bottom has a smaller bore which fit nice for the M6 thread) 1x 20mm spring (two were too much) 1x Pen holder of your own choice. I used this one: https://www.thingiverse.com/thing:261162 from EGoe 1x Analog Micro Servo (I used an Reely S-0009 MG) LaserGRBL also sends the pen lift signal to the servo output without any further settings. https://lasergrbl.com/ TIPP: Put the carriage in the down left corner and lift the pen with the servo a little above your working area BEFORE you power up the machine. Those will be your home positions. Have fun! The Audi in the pictures is about 40mm wide.Could have cleaned up the picture a little more...