Elongated functional finger claws

thingiverse

This is a remix of https://www.thingiverse.com/thing:2801033 I have elnogated the nails so that they're less raptor-like, but more wolverine-like — sraighter and a bit longer. # Instructions Begin with the "sizer" model. Scale it up by percentage- 150% should be a good start. It needs to fit your fingertip knuckle snugly, but not too tight! NOTE: you probably won't need to go over 200% scale. Mine where: Thumb- 190%, Index & middle 150%, ring 140%, pinky 125%. Once you have figured out your finger sizes, you can print your claws in the same ratio. The thumb model scales in the same way the regular fingers do. After they are printed, slip some elastic band through the slots and glue in place on either side.