Elusive Dart Launcher (E.D.L.)

thingiverse

Here is My newest blaster the EDL. It is based heavily on the FDL-2 as it was one of my favorite blasters. The pushers mech is the same as the FDL-2 (see FDl-2 for pusher assembly) but this runs normal 130 motors and flywheels. Wiring is the same as a (dead center) rapid strike or I do offer a custom board to make the wiring a little more clean. Most of the build uses 6/32 x 3/8 machine screws but 6/32 x 1/2, 3/4, and 1" will also be used and holes will need to be tapped. Hardware: 6/32 Machine Screws 3/8, 1/2, 3/4, 1 inch 19mm Latching Push Button Switch (on/Off) 16mm Momentary 3 post Push Button Switch (trigger) 12mm Momentary Push Button Switch (Rev) 2 9mm steel rods (Stock) 10/32 set screw and #10 washer (Pusher) 10A Cherry DB2 Micro switch with leaver .28" Volt Meter