Enclosure for Raspberry Pi + HiFi Berry

thingiverse

I am running a Raspberry Pi as an audio streamer (with Volumio) in my shop and enjoy it very much. After having the Raspberry Pi with the HiFi Berry sitting naked on the shop's table for some months, I finally decided to design an enclosure for it. I didn't like the way the Raspberry Pi has the connectors spread all around the board so the target was a clean and slick looking box with all the externals located on the back side. Printing is straight forward and the hardware and installation is shown in the pictures. The LED opening was sealed on the outside and then filled with clear epoxy from the inside. Two short RCA cables are soldered to the panel mount RCA jacks and a short dual wire runs from the DC jack to the DC supply pins of the HiFi Berry.