Enclosure heater for Elegoo Mars Pro 2

thingiverse

An adaptation of the FDM heater redesign by rsilvers which is itself inspired by the original https://www.thingiverse.com/thing:3442165 by X3msnake. Key differences: - No magnets as the Elegoo Mars Pro 2 is all aluminium in the enclosure. - A post type stand to raise the digital screen above the resin bath and potentially to be souble sided taped down to the printer. - Altered the body of the enclosure for ease of wiring and covered the open back with a lid built into the stand. I printed this on my venerable Makerbot 2x in ABS for heat resistence but PLA should be fine and added a standard DC pin connector. Print the body face down and the Stand back-side down, no need for supports but you can use them for the stand tube if you want a nice finish in there...you perfectionist. Wiring is easy, just make sure to use appropriate gauge wires for the power depending on which heater you use, I went for a 100W one which was probably overkill and 2.5 mm core wires. OTS Components: 100W 12V PTC Car Fan Air Heater 12V DC Thermostat Controller