Enclosure. RAMPS, Mega and LCD all in one.

thingiverse

**RAMPS, Mega and LCD all in one control box** *(work in progress)* **Control Box Enclosure (Big 250mm)** May be a little too big for some printers... **mounting holes not correctly aligned**... Print Time ~8hours @60mm/s & 0.3 ... **Control Box Enclosure (Medium 225mm)** Added a smaller version and **confirmed mounting holes positions**... Print Time ~9hours @60mm/s & 0.3... It appears that most people use two different enclosures for the RAMPS and LCD module and I'm guessing that's because of print size but as I have a CR-10 I decided to go with one enclosure... There's plenty of room inside and I added lots of vents for cooling. I tend to use 2mm walls in my designs but I could increase this if necessary, I'll check after the final print... **Caution:** The mounting hole for the PCB's in the *250mm* enclosure are not accurate, the smaller *225mm* version should be close to perfect but I have not printed a test print yet so please wait for confirmation before printing this 3D print... I'll make the FreeCAD files available for anyone with interest just as soon as I clean them up... **Updates** (225mm version) Only had time to print the top half to check LCD board alignment and mounting holes... perfect ~0.5mm, next for the main body (tomorrow 29th Oct 17)... Mike