Ender-2 XY & XYE TL Smoother bracket

prusaprinters

<p>Update 20200122: I've managed to make a design which can fit three (3) TL Smoothers into the factory Ender-2 electronic enclosure. It's an <strong>extremely</strong> tight fit, however, so make sure the wires are bent clear and be careful when re-installing the cover. Seriously, there's not even 0.5mm between the bottom of the plate and the enclosure.</p><p>A quick bracket designed to fit within the main control box to mount two (2) TL Smoothers, intended for use on the X and Y axes. It has been revised slightly since the pictures were taken but is still functionally identical.</p><p>Note that this may not fit all TL Smoothers, and likely won't work well with those having right-angle connectors due to space restrictions.</p><p><i>Update 20200717</i></p><p>Added a revised XY bracket. This should print quicker and more reliably, and provide a better fit for the smoothers. I've left the old XY STL in place in case anyone prefers the old design.</p><p>&nbsp;</p><p>Requires no supports or special bed adhesion. Be aware that it is a fairly broad print so it may be susceptible to uneven bed heat (if used) or a warped bed.</p><p>All vertical measurements were done to fit a 0.2mm layer height, but smaller heights should work without issue.</p>