Ender 3 - 5cm Feet (Can be used in any 40mm V-slot channel)

thingiverse

These feet are to raise your Ender 3 by 5cm. Tolerance was ok on my printer but I would suggest printing one first to check. Tip, if the part is too hard to push in, heat it gently with a lighter for 3-5 seconds and push it back in the rail. You can use a rubber mallet too :) I gave the print a slight arch so that it can support more weight if it's printed without top and bottom and without infill with 5 walls. I am using ASA. Can be done with PLA too. just go with 8-10 walls to be safe. It gives a more aesthetic look. You can also print it normally! It's really my opinion only :)