Ender 3 Pro AIO Electronics Box

thingiverse

This is a work in progress! I have finished printing the pieces and will begin assembly and photographing them soon. The project has grown into quite a lot of different options as my design, placement, and wiring decisions have evolved. Development notes: The case is very packed with wiring and circuit boards, so I had to put the fans on the outside instead of mounted to the inside/bottom of the covers. Also, two 30mm fans running at 24v are a little louder than I expected. I may redesign the cover for a larger single fan. Getting the 30mm fan cover into place is very difficult, because I mistakenly put them in the path of the Y stepper. I don't recommend it to be used. 4.25.20 - Added Raspberry Pi case with enhanced cutouts and bug fixes. Added 40mm fan opening cover plates: solid, 10A relay, and buck converter. Also remixed a fan cover to act as a vent if not using the fan.Added mirrored versions of right side 30 & 40mm fan covers to work on the left side. Added "modular" left side case (no fan, but with mounts for either relay or buck converter). Also added no fan, no mount version of the left side case. 4.24.20 - Created 40mm fan cutouts for right side. 4.15.20 - All four pieces have successfully printed. 4.13.20 - Successfully printed Right case with logo. 4.13.20 - Smoothed out front of Right Case without logo, uploaded revision 2. 4.12.20 - Discovered error with logo on Right Case during initial print, uploaded revision 2. 4.12.20 - Successfully printed Left case with Logo & 30A Relay. 4.12.20 - Swapped one of the 10A relays for a 30A relay on left case with logo. 4.11.20 - Uploaded cases with logos, cleaned up front surface. This is made of many, many different parts from a lot of people. I sincerely appreciate everyone's work, I basically just cut and pasted it all together. I have two 30mm fans from a previous Raspberry Pi case, so I added them to the cover over the mainboard. I couldn't manage to fit both a relay and a buck converter in the original left side bin and still be able to access the HDMI and micro USB ports. This remix allows for two buck converters on the right side and two relays on the left side, with as much space as is available for HDMI and micro USB. The fan covers are here: https://www.thingiverse.com/thing:3483359 Full model: https://www.tinkercad.com/things/3kuhVJwjfMz Left case, no logo, 2 10A relays: https://www.tinkercad.com/things/jeUB1Wd9zuk Left case, no logo, 1 10A relay and 1 30A relay: https://www.tinkercad.com/things/c2xbQwxrC4F Left case, logo, 1 10A relay and 1 30A relay: https://www.tinkercad.com/things/dl486PMHHDh Right case, no logo: https://www.tinkercad.com/things/aPSunWHKPWb Right case, logo: https://www.tinkercad.com/things/iJkiTwgSg7T