Ender 3 Pro Raspberry Pi 3b+ Caddy

thingiverse

Remixed from (used the slots to fit into extrusions) https://www.thingiverse.com/thing:4751688 I already had a case for my Raspberry Pi that I Knew fit perfectly so I designed this little caddy that sits in the extrusion slots and supports the pi on the side of the printer. Will probably fit a fair few cases as I didn't make the tolerances super tight. It is open at the bottom to allow ventilation and allows access for camera Ribbon cable. There is a locating slot that sits in the GPIO pin access hole the keep the pi on place. So obviously this isn't suitable if you are using the GPIO pins. No tools or hardware required print upright using supports, 20% infill