Ender 3 rear box for SKR1.3

thingiverse

I've decided to make my own rear box for Ender3 to house SKR 1.3 because the stock box with improvised fan ( mounted externally ) wasn't efficient enough and was too loud. I've also wanted to add in Octoprint and tidy things up a bit when it comes to buck converters ( they were ghetto modded in different ways ) Also, I've tried to use a minimal amount of plastic so the bottom side is not covered in full Box is made for Bigtreetech SKR1.3 and has the option to install 2 smaller buck converters + 1 larger buck converter. Orange Pi zero and Noctua 40mm cooling fan ( I'm using TMC2208 drivers ) for motor drivers which get quite hot and step skipping manifests during longer prints. Currently, my E3 has makerbase TFT25 but due constant issues ( only appear sometimes ) with reading from USB sticks or sd cards I've decided to go with Octoprint. ------- Current version v1.0 issues: - need to punch thru all component mounting holes all the way thru the bottom --! important -> box width issue is fixed but rails are missing from Thingiverse collection ( hopefully I'll add these soon ) ---- Important info: the box was printed on Artillery X1 ( 300x300 bed ) without supports (the design was made in a way that we don't need to use supports - to reduce plastic waste )