Ender 3 S1 (pro) Cableholder mod

thingiverse

Secures the unprotected cables for the X axis motor and X axis limit switch. This is a quick-and-dirty mod, but apparently it still fits and does a better job than the original imo. In the image you can see a comparison, the original broke on the initial install attempt and had to be glued. It hasn't been on that long, but the clamp-part has already bent. (probably my fault for using regular PLA though) I'm using a zip-tie and a piece of bicycle tube to ensure clamping pressure. You should use some heat-resistant filament and avoid regular PLA, so you don't end up with creep like I did. Without an enclosure it's still gonne be fine, probably. But don't say I didn't warn you. ;) Installation advice: move z to the top and x to the right BEFORE installation! (Y is the carriage, right?) That way you cannot insert the cable at the wrong spot like I did. TWICE. :-( See that blank spot at the cable for the end stop? Don't hurt your poor printer like I did, it's not his fault, creality can't get it right on their umptieth attempt. ¯\_(ツ)_/¯ use the .stl or the.obj, whichever you prefer, they're identical. ->Thanks to the original designer, I couldn't have done the measurements myself.