Ender 3 V2 Extended Squashball Feet T-Nut - 25mm extra

thingiverse

Remixed the squashball feet in this pack to be extended an extra 25mm so that I could fit larger drawers and also improve airflow. These I have removed the built in V slot holders as it can be difficult to install them if you extrude a bit to much. These install with T nuts. 30mm bolts should work but it will depend on your type of T nut that you are using so it may have to be a bit longer. I also have a remix that keeps the original v slot that are installed if you prefer. Use infill for the small lift that the 2 feet have to make room for the power supply. Remove the 2 screws on the back of the power supply as they will be in the way of the feet and the feet will hold it in place with pressure.