Ender 3 V2 Raspberry Pi Case

thingiverse

Printed with White PETG because this is the only white filament I have. It will look better if printed with PLA. I didn't put a fan in the design because I have modded the original 40mm controller fan with a 80mm fan, it pushes a lot of air through the vents, should also be able to cool down the Pi. Fan Mods I used: https://www.thingiverse.com/thing:4549738 https://www.thingiverse.com/thing:4548187 Camera Case I used: https://www.thingiverse.com/thing:2987719 I soldered the USB2.0 D+ and D- directly on the controller board, as well as on my RaspberryPi 4. And connected a power wire from the PSU to a LM2596 to get 5V to power the Pi directly from its GPIO pins. So I don't need to run any cable (except for the camera) outside the case. The top cover is separated, so future mods can be done easily. I am planning to make another LCD screen into the top cover, for OctoPrint. I have included the f3d design files so you can make changes and tweaks.