Ender 3 Vyper Clip On Webcam Mount

thingiverse

This is a clip on webcam mount for the Creality Ender 3 and Anycubic Vyper. The mount can be clipped on to the side and a pin can be printed for the Swivel arm. The mount is slightly tight and needs a little wiggle and it will clip into place. I made a slightly bigger diameter pin (6.5mm) than the original, which I found to be too loose. Both the hole on the arm and the pin needs a little cleaning/sanding to fit the pin. Requires controlled twist and push to fit the pin.. do not put excessive force.. also control the cleaning of the hole and pin so it will not be too loose. The webcam was attached by doing a hack with an Ender 3 Stock spring and an M6 bolt. (see photo) The short arm can be downloaded from https://www.thingiverse.com/thing:5201421 which I found a little short. I have done a remix of the arm, to make it longer. It is 175mm long. This is a remix of: thing:5201421 (https://www.thingiverse.com/thing:5201421) by damondarnell1 which is a remix of thing:3147743 (https://www.thingiverse.com/thing:3147743) by aallensd [Update 01-26-2022]: Remixed and added a longer Webcam mount arm total length - 175mm