Ender 3 X-Gantry Octoprint Monitor

thingiverse

Update 21/12/2019 - Added file OctoMonitor_Mount_v2.stl, I have increased the width of the slot for the Wemos board by 0.8mm to more comfortably fit the v3 revision as requested by donsadlerjr in the comments and uploaded an updated step file. As mentioned below the initial file does fit the new v3 Wemos Mini however the tolerance is very tight so getting the board out again proves difficult unless you break the printed part, I personally preferred it this way as stay put when unplugging the USB cable. Just a simple clip on case for the Ender 3 X gantry to house my Octoprint Monitor. I just wanted a quick way to check on my print status without needing to approach the printer to open the LCD cover I have on it & kept misplacing the Octoprint Monitor when using the original free standing case designed by Qrome. Designed to comfortably fit a [Wemos D1 Mini v2.2.0](https://www.banggood.com/Geekcreit-D1-mini-V2_2_0-WIFI-Internet-Development-Board-Based-ESP8266-4MB-FLASH-ESP-12S-Chip-p-1143874.html?rmmds=search&cur_warehouse=CN), I have obtained a v3 board since designing this and it does fit however tolerances are extremely tight and you may need to break the case if you need to remove the board. The mount for the [0.96" OLED](https://www.banggood.com/0_96-Inch-4Pin-White-IIC-I2C-OLED-Display-Module-12864-LED-For-Arduino-p-958196.html?rmmds=myorder&cur_warehouse=CN) is designed to be press fit, please make sure to be extremely gentle to avoid damaging the LCD. Credit to Qrome for his OctoPrint Monitor, if you would like to make your own be sure to check out his [Github](https://github.com/Qrome/printer-monitor) for the code & build instructions. I have included my step file if you want to make some changes, still a novice so my apologies if the timeline on design changes etc is a bit messy :) If you do make changes to the designs please include the step file if you post a remix so that other users can also benefit.