Ender 3v2 (and others) OpenSCAD adxl345 Mount for Klipper Resonance Tuning

prusaprinters

<h5>Ender 3v2 X and Y mounts for adxl345 for Klipper Resonance Tuning</h5><p>This print was inspired by <a href="https://www.thingiverse.com/thing:4882714">https://www.thingiverse.com/thing:4882714</a></p><p>These are low-profile mounts that clip on the X gantry and the printer bed + surface. &nbsp;They are a friction fit. &nbsp;All parameters are clearly labeled in the code and can be changed to match your board.</p><p>I used this board: <a href="https://www.amazon.com/dp/B07DMZCGP9">https://www.amazon.com/dp/B07DMZCGP9</a> and this makes up the “GENERIC” profile. &nbsp;There is also an “ADAFRUIT” profile that I based on their datasheet but it is untested. &nbsp;I coded that “block” for a friend and while I was doing it, he made his own print. &nbsp;It should be fairly close, though.</p><p>Measure your board with calipers, change the values if you need to and print it out. &nbsp;Both mounts are very small and print fast. &nbsp;I don't think a lot of precision is needed here. &nbsp;Your mileage may vary.</p><p>I did not have any issues with the mounts moving during the tests whatsoever. &nbsp;They were snug but not overly so. &nbsp;I made one in PLA and one in PETG.</p><h5>Instructions</h5><p>The instructions are fairly simple and are included in the initial comments. &nbsp;You will need to download OpenSCAD. &nbsp;It's the price you pay for a free print.</p><p>Don't worry, it's a cakewalk. &nbsp;Go for it.</p>