Ender 3V2 Dual Duct Satsana 5015 Blower fans +BLT

thingiverse

Remixed this to fit a Ender 3v2. It also fits the ender 3 as I left the holes there. you need m3 screws, I used m3*8 and*12-16 for securing it to the stock carriage.I also included a X switch stop because by adding the BLT to it the satsana alone does not hit the switch and will cause a homing error. Print the satsana on its back, and the x stop (it slides onto the satsana, see pictures) on its side. No supports. I printed at .32 layer height, you can print at whatever height you'd like, .2 and above. BLT probe to nozzle offset is as follows. X offset: -54mm Y offset: -16mm Also, because you now have a larger fan housing than stock, your nozzle sits over to the right more. So you have to adjust that x offset on the slicer (different than from adjusting the BLT offsets). I use Cura and provided a picture. You can find the setting under manage printers, click on the extruder tab, change the x offset. 15mm works well. I decided 16.5mm for me because I have a 220x220 PEI bed on top of my stock glass (not cencetered, thus 16.5mm works for me). adjust as necessary for your printer but 15mm is pretty dead center I think. Post some pictures of your makes! God bless.