Ender 3V2 Unitak Direct Drive wire guide

thingiverse

Ender 3V2 Unitak Direct Drive wire guide No amount of zip ties and trying have I ever managed to get all the wires in a place that didnt either catch on the frame when calibrating before a print or when bed levelling, or if i did it looked an eye sore. Im not going to lie to you and say this is easy to fit because it aint if you have a fully assembled hot end. the way ive done it is 2x10mm M3 bolts pinched with tweezers and inserted from belowand into the 2 spare holes you have on the DD mount you have. then the guide placed over the 2 bolts, tweezers to push the bolts up and secured with a nut! took me a cple of attempts and 1 lost nut! but its on and now i finally have fixed wires that are tidy and not in the way of anything only taken 3 years to do it! mines in CF PETG 237'c 80'c 45mm .5 noz .3 layer 20% infill Gyroid 35 min print