Ender 5 - LCD Panel Back Cover - Snap on

thingiverse

I noticed there are no covers for the LCD panel that is exposed on the back of the Ender 5 LCD. This design was to save time, material and get the job done. I've been using my printer for quite some time and this cover has been holding up great, does not fall off, etc. Print & Install by pressing it to snap, no need to remove screws or anything like that. On my original design I had to cut off the bottom part for the bottom speaker, I enlarged this to allow for more play by 2mm in this uploaded design. If you need to cut a little just do, I did not test the final design but even before the change, there no issue installing this. This print does not have to be detailed so print with the low resolution of your printer and it will hold on great.