Ender 5 Limit Switch Cover with Wire Guard

thingiverse

I found that my tubes and wires would sometimes end up in front of the limit switch when the printer header would go to the far corner, messing up the print (because the switch would activate early). I remixed the limit switch cover by mhtech to add wire guards on either side - on the inside to pevent the wires / tubes from getting stuck in front of the switch, and on the outside to give them a smooth "off ramp" from the switch. This is a remix of: [Ender 5 limit switch cover](https://www.thingiverse.com/thing:4086566)