Ender 5 Pulley Bracket

thingiverse

This was built to offset the belt on my Ender 5. I bought pulleys from Amazon, which are wider than I expected, so that's what was targeted in this design. It can also print without support, just rotate 90 degrees so that it's lying on it's side. You'll need 4 3mm screws to replace the hood on the motor. This also uses 2 5mm screws. One to hold the pulley, another with a T-nut to fasten into the rail. (the second might not be needed but I designed it in to allow some adjustment after printing.) Parts Used: 1 - M5x20 Bolt 1 - M5x8 Bolt 1 - M5 T-Slot Nut 4 - M3x8 Bolts