Ender 6 linear X and Y guides

cults3d

----NOTE UPDATE--- 13-4-22 1.2 Y-axis linear supports are corrected to avoid some errors with end-of-stroke detection in some versions of Ender 6 14-11-21 1.1 - Corrected an error in uploading the files for the Y-axis linear support as they were undersized, the new ones are uploaded with more room for placement. With these designs, we have planned to install linear guides in X and Y axes. the main idea of these guides I have been inspired by other public models but solving errors and improving them as well as adapting them to my previous models being a pack The installation of these mods are not complicated but we will need some tips and materials. We will need: 3 linear guides 350mm and MGN12H https://ali.ski/KqcfU M3x8mm bolts and T-M3 sockets to anchor the linear guide and runners. 4 screws M4x30mm 4 screws M4x8mm or 10mm and 4 nuts T-M4 4 M5 screws minimum 22mm maximum 24mm 4 nuts M5 optional: knurled nuts M5 optional: M3 nuts 1.Print mod with very strong PETG parameters,10 perimeters,60%-80% filling. 2.Y axis, disassemble the side wheels and the X profile, insert the Y axis parts taking into account that the part acting on the limit switch goes to the right, placing two M4x8mm or 10mm screws with T-M4 nuts on the sides of the part and inserting the 20x20 profile. insert the upper M4x30mm screws and anchor them to the pulley supports. 3.Place the linear guides on Y axes with the runners with at least one screw every two holes and leave them fixed but not tightened. 4.Anchor the printed brackets already installed on the X-axis and fix them with M3x8mm screws to the runners without tightening them completely. Tighten the screws of the linear guides checking that they are not twisted use a caliper or simply if you are an expert checking the slider guiding. 6.Tighten the screws of the skates, that they remain fixed by tightening crosswise but without tightening too much since they deform the skate and slow it down. If everything goes smoothly, we repeat the guide step on the X-axis. For X axis we will have to remove the original screws and wheels and replace them with M5 screws, which will anchor the printed piece with M5 nuts that we will introduce through the slots which are indicated in the mod and we will anchor it to the original base. Screw the linear guide as level as possible and screw the skid as in the previous skids. 9.If you have my other mods you can install a reinforced bracket for the cable trough, which will tie all the pieces together more. Lubricate the guides well with lithium grease and check that they don't rub, and you're done. 11.Check the tension of the belts. 11.OPTIONAL insert M5 knurled nuts for better grip on the X axis linear mod.