Ender 6 with top cover, CoreXY Cablechain Rear Mount

thingiverse

I remixed the rear mount as my Ender-6 has the Top cover and the rear mount blocks it as it sat on the rop rail. I altered it so it only sits on the top rail by 5mm and clears the top cover. The rear was also modified to make it a little easier to get the cables through it. I used 100% infill as test prints showed it could break as the chain put a bit of tension on it but at 100% infill it seems fine. I used tree supports to get a clean print and orientated it upside down, the STL is saved in that orientation. This rear mount was remixed from https://www.thingiverse.com/thing:4731935