Ender Adjustable Limit Switch

thingiverse

I designed this after installing a V6 hotend which sticks out a few millimeters more than the Ender’s stock hotend. When adjusting the endstop, make sure to secure it just before the wheels of the Y-carriage collide with the corner braces. While I’ve only installed this on an Ender 5, it should work fine in many scenarios where the endstop is mounted to a v-slot or via a single screw. All screws are transferred from the original part. With the stock hotend it’s still possible to gain a couple of millimeters of Y-axis by replacing the end stop.