Ender3Max Bed Lowering Z-Stop

thingiverse

Adjustable z axis switch mount for the Ender 3 Max. I may upload a heightening version, because i noticed that my bed is like a mountain (high in the middle, low at the edges). Everything fits perfectly (this is an internal revision 10) gives back up to 5mm of bed height (again, the bed may be a mountain at that point). The switch mounting holes are not threaded, but ready to take and hold some screws (hand tighten). This was made measuring out the original z-stop mount. I suggest using the following settings: -Cura standard profile -3-4 walls on the shell (mostly due to the holes getting squished when mounting to the frame) -30% or higher cubic subdivision infill (again, mostly due to the holes getting squished when mounting to the frame) -build plate adhesion as you wish (or as your printer/printing environment dictates)