Endrer3v2 riser feet

cults3d

Raise your printer with 38mm or even 45mm clearance while reusing the original rubber feet that came with the ender3v2. Great for installing larger quiet fans on the underbelly fo the printer. The 38mm and the 45mm are the approximate clearance height from ground to bottom of the printer, so that value includes printed foot + rubber height When installing the vertical wall of the foot should faced toward the printer to not conflict with any printed undercarriage. To install remove the original rubber feet (just rips the rubber feet right off, they are only held by glue), cleanup the glue on the printer side, not squeaky clean, just enough to not have big chunks of glue, which would make it too hard to slide the feet. Keep some of the glue to add friction. Keep any glue residue on the rubber feet. For the front left side, remove the two front screw and the two bottom screw that are on the edge. And you'll be able to left the aluminum plate just enough to slide that foot on. (picture showcase 48mm clearance version)