ESC Case for Afro 12A

thingiverse

Here is a small stand alone case for the 12A Afro ESC. It may be of use to some people. I was inspired by another case someone had made for a 30A version, Part requires two M2 sized nuts to be pressed into the hex shaped holes after printing. Also the hole for the status LED isnt present in the STL, I drilled that later. I removed the wires from my ESC's (I wouldn't recommend this, bullet connectors were hard to align) With this case you may also be able to add a small heat sink pad (one of those squishy ones) to the MOSFETs The fit may be a little tight, so some filling will be required, especially where the servo wires exit. Print Settings Printer Brand: RepRap Printer: 3Drag