ESP32-WROOM-32D Dupont Case

thingiverse

This is designed to hold an ESP32 with pin headers soldered on and allow you to use dupont connectors with it. As the filenames imply, this was built with the ESP32-WROOM-32D in mind, specifically the one from HiLetGo. The main components consist of a cover, board carrier, and base to house additional electronics. There are two variants of the design, standard and long. The longer variants are identified by a '-L' at the end of the name. * **ESP32-WROOM-32D Base** - Basic shell with enough room to shove some sensors into. No mounting methods are on this...just a box waiting to be filled with your goodies. * **ESP32-WROOM-32D Carrier** - This piece holds the ESP32 itself. There is a notch in the back to hold the board in place. When printed with a .1 layer height, it's a solid fit that firmly holds the board in place. * **ESP32-WROOM-32D Cover** - Simple cover that goes over an ESP32 with vents for the SoC and pin holes for the two buttons * **ESP32-WROOM-32D APD-9960 Luminance** - Standard base with cutouts and mount points for the APD-9960 Luminance sensor with a larger hole to stick a 2" suction cup through for mounting onto a glass surface. * **ESP32-WROOM-32D BH1750 Light Sensor** - Standard base with cutouts and mount points for the BH1750 lux sensor with an additional hole for a 2" suction cup. * **SRD-03VDC-SL-C Relay** - Long base designed to house an [SRD-03VDC-SL0C relay](https://www.amazon.com/gp/product/B07PNB86R7). This relay is capable of being switched by a 3v signal and can handle 30vdc, perfect for most garage door openers. **Update 12/4/2021** Added longer variants of base, carrier, and cover as well as a long case designed for a relay. The long variants are identified by a '-L' at the end of the names. This is a work in progress where I will post additional base designs as the need/request arises.